The Ultimate Guide to Using Heskins Keying Agent on Low Energy Surfaces

At Heskins, we know applying anti-slip tape to low energy surfaces is tricky. To overcome this problem, we have created our keying agent, a substantial advancement in adhesive technology. This guide will show you how to use our keying agent and apply anti-slip products to low-energy surfaces.

What You Will Need:

Non-Slip Tape
IPA Surface Cleaner
Gloves
Cloth
Keying Agent
Seam Roller
Edge Fix

Ensure you have the correct equipment on hand. If not, this could have adverse effects between steps.

Step 1 – Clean the Surface With IPA Cleaner

Wear gloves, as some chemicals could be harsh and unsafe on bare skin. Use H3508 IPA surface cleaner and a dry cloth to wipe down the low energy surface ready for application, as shown in the image. This step will help prolong the life of the adhesive once it’s applied to the surface by removing all the potential contaminants that could affect the tape’s bond.

Clean with IPA cleaner Clean icon

Step 2 – Apply a Small Amount of Keying Agent

Apply Heskins H3510 keying agent to the low-energy surface. Wipe a small amount onto t surface using a cloth. This step ensures the surface is ready for applying the anti-slip tape.

Apply keying agent Clean

Step 3 – Peel Off the Adhesive Backing Liner

As shown in the image, peel off the anti-slip tape’s backing liner and place it down firmly onto the low energy surface. It is crucial to apply firm, even pressure, on top of the tape to improve the bond.

Peel off backing Peel icon

Step 4 – Using A Seam Roller, Remove Air Bubbles

Use a seam roller to remove any air bubbles that may have formed underneath the tape. This step prolongs the life of Heskins anti-slip tape. If air bubbles aren’t removed, it could cause creases in the material over time and edge lift. Using a seam roller ensures Heskins anti-slip tape lays perfectly flat and the adhesive layer strongly connects with the low-energy surface.

Application seam roller seam roller icon

Step 5 – Seal the Edges with Edge Sealant

This is the final step when applying anti-slip tape on low-energy surfaces. For this step, you will need Heskins H3502 edge fix. Begin applying it to each edge of the tape, as shown, ensuring it’s a consistent line and you’re not using too much. Edge fix helps extend the life of the non-slip tape. It acts as a glue to keep the edges secured to the surface, preventing water or dirt from getting underneath the anti-slip tape.

Seal Edges Edge fix icon

What is Heskins Keying Agent?

Keying Agent is a Heskins solution in the battle between low-energy surfaces and adhesive tape. Keying agents increase the effectiveness of Heskins anti-slip solutions remaining stuck to low energy surfaces such as certain plastics.